|
The initial stake will be the same as that set in the box. When we have a loss the ‘Recovery’ tick box becomes
activated and the loss to be recovered is shown in Current Values. When the recovery ends, the box becomes
unchecked again. During the recovery the number of bets and cycles are shown.
You can set the number of bets to recover the loss % over and also the amount to be recovered over each race.
This could be 100% for 1 bet or 50% for 2 bets whatever your strategy requires. The number of recovery cycles
determines how many times you try to recover the loss if another loss occurs before the recovery has finished.
ie. additional attempts at recovery.
If you set the number of cycles to 0 you will have unlimited cycles i.e. It will keep going. Unlimited cycles can
be very risky.
You can also decide to recover the lost stake if necessary by ticking the “include lost stake” option.
Backing with recovery stake can only recover over 1 race instead of a number of races. The stake/recovery
depends on the odds of the next selection.
The Action variable allows you to set two options for what happens when the number of recovery cycles is
equaled. ie number of additional recovery attempts.
1.Stop
2.Reset
Once the recovery stake has been triggered by a loss, the recovery will finish if the number of recovery
bets has been completed. The stake is then reset to the initial stake again and waits for another loss.
If we have another loss within the recovery procedure, the next cycle is started until we reach the
max number of recovery cycles.
If Stop is selected the Bot will stop when the number of cycles are met.
If Reset is selected the Bot will return to the initial stake and reset the recovery ready for another loss.
The Bot will continue betting and can start a complete recovery process again.
If you should end the day or your selections with a loss in recovery mode you can tick the Keep Values
After Reload box so when you load races the next day the recovery will continue where it left off.
Of course if the max loss is exceeded at any time the bot will stop.
In the example below you can see a loss occurred on the 13:12 Perry Bar of -3.30.
The next stake then for the following two bets will be:
50% x 3.30 + 1.00 (stake for current bet) = 2.65
When the two bets have been completed successfully the stake will return to 1.00.
The screenshot below is the old version 4.2 of the software for staking demonstrations
| 
