Basically its a reverse of custom multiplier with some mods. It goes through the multiplier sequence after a winning bet
and resets after a loss to the beginning of the sequence.
1) You need to enter the initial stake and multiplier sequence as per custom multiplier
2) + 1 up the sequence if we win (custom multiplier goes up one if we lose), Sequence might be 1x,2,3x,4x,5x,6x,7x,8x etc . Revert to 1st multiplier after any loss or after a win at a cycle target. Stay at 1st multiplier with consecutive losses until a win.
3) Cycle target needs to be set, this allows a cycle to complete and reset. ie example might be a 5 cycle target which would be 5 wins in a row and then back to 1st multiplier.
4) Check box to enable - Stay at Max - if ticked and you reach the end of the multiplier sequence ie 8x, it will continue at 8x until a loss is reached. The cycle target would need to allow for additional bets to be made if this was the case. ie 1-8x multiplier, cycle target 10, stay at max ticked would allow two extra bets at 8x.
